A Novel Nickel-Plated Carbon Fiber Insert in Aluminum Joints with Thermoplastic ABS Polymer or Stainless Steel.

New types of hybrid aluminum joints: Al-acrylonitrile butadiene styrene (ABS) carbon fiber reinforced thermoplastic polymer (CFRTP) designated Al/ Ni -CFP/ABS, and Al-18-8 Stainless steel, Al/ Ni -CFP/18-8, by Ni-plated carbon fiber plug (Ni-CFP) insert not before seen in the literature have been fabricated. The goal is to take advantage of extremely high ~6 mm CF surface area for high adhesion, to enhance the safety level of aircraft and other parts. This is without fasteners, chemical treatment, or glue. First, the CFP is plated with Ni. Second, the higher melting point half-length is spot welded to the CFP; and third, the remaining half-length is fabricated. The ultimate tensile strength (UTS) of Al/ Ni -CFP/ABS was raised 15 times over that of Al/ABS. Normalized c UTS according to CFP cross-section by Rule of Mixtures for c Al/ Ni -CFP/18-8 was raised over that of c Al/ Ni -CFP/18-8 from 140 to 360 MPa. Resistance energy to tensile deformation, U T , was raised 12 times from Al/ABS to Al/ Ni -CFP/ABS, and 6 times from Al/CFP/18-8 to Al/ Ni -CFP/18-8. Spot welding allows rapid melting followed by rapid solidification for amorphous metal structures minimizing grain boundaries. The Ni-coating lowers or counters the effects of brittle Al 4 C 3 and Fe x C formation at the interface and prevents damage by impingement to CFs, allowing joints to take on more of the load.