Cs 3 Cu 2 I 5 /ZnO Heterostructure for Flexible Visible-Blind Ultraviolet Photodetection.
Xinhong ZhaoYu TaoJixiang DongYongchu FangXiaoxian SongZaoxue YanPublished in: ACS applied materials & interfaces (2022)
Wearable, portable, and biocompatible optoelectronic devices made of all-green and abundant materials and fabricated by low-temperature solution method are the key point in the development of next generation of intelligent optoelectronics. However, this is usually limited by the weaknesses of mono-component materials, such as non-adjustable photoresponse region, high carrier recombination rate, high signal-to-noise ratio, as well as the weak mechanical flexibility of bulk films. In this work, the Cs 3 Cu 2 I 5 /ZnO heterostructure flexible photodetectors were constructed by a low-temperature solution method combined with spin-coating technique. The heterostructure combines the low dark current and strong deep ultraviolet absorption of Cs 3 Cu 2 I 5 quantum dots with the high carrier mobility of ZnO quantum dots as well as the efficient charge separation of the vertical p-n junction, to improve the photodetection performance. The heterostructure shows enhanced light/dark current ratio and ultraviolet-to-visible rejection ratios. Under an illumination of 280 nm light, an optical detectivity as high as 1.26 × 10 11 Jones was obtained; the optical responsivity and response time are much better than those of control devices. After 300 times of 180° bending cycles, the photocurrent had no obvious change. The results demonstrate that the Cs 3 Cu 2 I 5 /ZnO heterostructure has great potential in wearable and portable visible-blind ultraviolet optoelectronic devices.