Login / Signup

Dependence of Photoresponsivity and On/Off Ratio on Quantum Dot Density in Quantum Dot Sensitized MoS2 Photodetector.

Yung-Yu LaiYen-Wei YehAn-Jye TzouYi-Yuan ChenYew Chung Sermon WuYuh-Jen ChengHao-Chung Kuo
Published in: Nanomaterials (Basel, Switzerland) (2020)
Non-radiative energy transfer (NRET) from quantum dots (QDs) to monolayer MoS2 has been shown to greatly enhance the photoresponsivity of the MoS2 photodetector, lifting the limitations imposed by monolayer absorption thickness. Studies were often performed on a photodetector with a channel length of only a few μm and an active area of a few μm2. Here, we demonstrate a QD sensitized monolayer MoS2 photodetector with a large channel length of 40 μm and an active area of 0.13 mm2. The QD sensitizing coating greatly enhances photoresponsivity by 14-fold at 1.3 μW illumination power, as compared with a plain monolayer MoS2 photodetector without QD coating. The photoresponsivity enhancement increases as QD coating density increases. However, QD coating also causes dark current to increase due to charge doping from QD on MoS2. At low QD density, the increase of photocurrent is much larger than the increase of dark current, resulting in a significant enhancement of the signal on/off ratio. As QD density increases, the increase of photocurrent becomes slower than the increase of dark current. As a result, photoresponsivity increases, but the on/off ratio decreases. This inverse dependence on QD density is an important factor to consider in the QD sensitized photodetector design.
Keyphrases
  • quantum dots
  • energy transfer
  • room temperature
  • sensitive detection
  • reduced graphene oxide