Fluorometer Control and Readout Using an Arduino Nano 33 BLE Sense Board.
Zechariah B KitzhaberCaitlyn M EnglishKazi Ragib I SanimMichail KalaitzakisBhanuprakash KosarajuMichael E HodgsonNikolaos I VitzilaiosTammi L RichardsonMichael L MyrickPublished in: Applied spectroscopy (2022)
We describe the control and interfacing of a fluorometer designed for aerial drone-based measurements of chlorophyll- a using an Arduino Nano 33 BLE Sense board. This 64 MHz controller board provided suitable resolution and speed for analog-to-digital (ADC) conversion, processed data, handled communications via the Robot Operating System (ROS) and included a variety of built-in sensors that were used to monitor the fluorometer for vibration, acoustic noise, water leaks and overheating. The fluorometer was integrated into a small Uncrewed Aircraft System (sUAS) for automated water sampling through a Raspberry Pi master computer using the ROS. The average power consumption was 1.1 W. A signal standard deviation of 334 µV was achieved for the fluorescence blank measurement, mainly determined by the input noise equivalent power of the transimpedance amplifier. An ADC precision of 130 µV for 10 Hz chopped measurements was achieved for signals in the input range 0-600 mV.