The impact of free-radical stabilization techniques on in vivo subsurface mechanical properties in highly cross-linked polyethylene acetabular liners.

Highly cross-linked polyethylene (HXLPE) for total hip arthroplasty was developed to improve wear resistance in vivo and associated complications in comparison to ultrahigh molecular weight polyethylene. This material typically goes through various free-radical stabilization techniques by remelting, single-annealing, or sequentially annealing the polyethylene to improve in vivo oxidation and wear properties. The purpose of this study is to determine if there is evidence of subsurface microhardness changes in retrieved HXLPE liner at the rim and articular subsurface after extended in vivo time that could be associated with oxidation and its effects on mechanical properties and implant integrity. Retrieved HXLPE liners were chosen based on peak subsurface Fourier transform infrared spectroscopy oxidation values. Each was mechanically tested for subsurface microhardness at both the rim and articular surface using a validated microindentation technique. Rim testing demonstrated a decrease in mechanical integrity that corresponded to higher subsurface oxidation values regardless of the free-radical stabilization technique. At the articular surface, a decrease in mechanical integrity was observed near the surface corresponding to peak oxidation and Vicker's hardness, which decreased with increasing depths. This was found in all groups, with the exception of the single-annealed liners, which demonstrated decreased mechanical integrity trends at greater depths between 1.0 and 2.0 mm. Our results suggest that subsurface mechanical properties do change in vivo for certain implants. Though it is likely that the mechanical failures are multifactorial, we have shown that mechanical property degradation of HXLPE liners does occur with long-term in vivo exposure and should be considered a possible risk factor.