Morphological Regulation of Printed Low-Temperature Conductive Ink.

The unbalanced evaporation of solvents in low-temperature sintered inks for printed electronics leads to a series of problems in the actual printing process, including printed pattern distortion, surface cracking, and the coffee ring effect, which has become a serious obstacle to this technique. Here, we present a comprehensive investigation of the influence of the solvent composition, environmental, and sintering conditions on the complicated pattern formation process of reactive silver inks. The results first showed that only inks with a certain wettability of solvents could form well-defined patterns. Then, the solvent composition and ambient humidity can be adjusted to balance the nonequilibrium evaporative flow within the liquid and thus to obtain a flat liquid film. Combined with the rapid UV sintering process, the particle size, porosity, and roughness could be controlled to produce dense and homogeneous silver films. Finally, we successfully printed silver electrodes with a smooth and dense surface ( R qs ∼ 21 nm in 0.8 × 0.8 mm 2 area and less than 1% porosity) under an optimized relative humidity (RH) of 50-60% at room temperature with the solvent composition of IPA (isopropanol)/2,3-BD (2,3-butanediol) = 8:2. In addition, we also demonstrated high-performance Pr-IZO (praseodymium-doped indium-zinc oxide) thin film transistors (TFTs) with a mobility (μ sat ) of 2.14 cm 2 /V/s and I on / I off ratio of over 10 7 using source-drain electrodes printed under optimized conditions.