Influences of Toothbrushing and Different Toothpastes on the Surface Roughness and Color Stability of Interim Prosthodontic Materials.

The surface properties and color stability of interim crown materials may vary depending on the toothbrushing procedure. This study aimed to investigate the effects of toothbrushing and different toothpastes on the surface roughness (R a ) and color stability of different interim crown materials. Disc-shaped specimens were prepared from four interim crown materials (Tab 2000 (ChPM), Imident (LaPM), Protemp 4 (ChDM), and Telio-CAD (CadPM)). Specimens were divided into four subgroups for the control group (Cnt) and for simulated toothbrushing with distilled water (Dw) or with two different toothpastes (whitening toothpaste (WTp), activated charcoal toothpaste (ACTp)). The specimens' R a values were measured before and after 10,000 cycles of toothbrushing. The color parameters were measured and the color differences (ΔE 00 ) were calculated. Data were statistically analyzed by two-way analysis of variance (ANOVA) and Tukey's HSD tests. A significant increase in the R a values was observed after toothbrushing, except for the LaPM_Dw, ChDM_Dw, and all the CadPM specimens ( p < 0.05). Toothbrushing with toothpastes increased the ΔE 00 values of all ChPM and ChDM interim materials ( p < 0.05). Before and after all toothbrushing procedures, the CadPM specimens had smoother and ChPM specimens had rougher surfaces than the other interim materials. The two tested toothpastes had similar effects on the R a of all interim materials. Non-perceivable color changes were seen only with the CadPM_Dw group.