Tribological Properties of WS 2 Thin Films Containing Graphite-like Carbon and Ni Interlayers.
Roman I RomanovDmitry V FominskiMaxim V DeminMariya D GritskevichNatalia V DoroshinaValentin S VolkovVyacheslav Yu FominskiPublished in: Materials (Basel, Switzerland) (2022)
The development and production of thin-film coatings having very low friction is an urgent problem of materials science. One of the most promising solutions is the fabrication of special nanocomposites containing transition-metal dichalcogenides and various carbon-based nanophases. This study aims to explore the influence of graphite-like carbon (g-C) and Ni interface layers on the tribological properties of thin WS 2 films. Nanocrystalline WS 2 films were created by reactive pulsed laser deposition (PLD) in H 2 S at 500 °C. Between the two WS 2 nanolayers, g-C and Ni nanofilms were fabricated by PLD at 700 and 22 °C, respectively. Tribotesting was carried out in a nitrogen-enriched atmosphere by the reciprocal sliding of a steel counterbody under a relatively low load of 1 N. For single-layer WS 2 films, the friction coefficient was ~0.04. The application of g-C films did not noticeably improve the tribological properties of WS 2 -based films. However, the application of thin films of g-C and Ni reduced the friction coefficient to 0.013, thus, approaching superlubricity. The island morphology of the Ni nanofilm ensured WS 2 retention and altered the contact area between the counterbody and the film surface. The catalytic properties of nickel facilitated the introduction of S and H atoms into g-C. The sliding of WS 2 nanoplates against an amorphous g-C(S, H) nanolayer caused a lower coefficient of friction than the relative sliding of WS 2 nanoplates. The detected behavior of the prepared thin films suggests a new strategy of designing antifriction coatings for practical applications and highlights the ample opportunities of laser techniques in the formation of promising thin-film coatings.