Plasmochemical Modification of Crofer 22APU for Intermediate-Temperature Solid Oxide Fuel Cell Interconnects Using RF PA CVD Method.
Marta JanuśKarol KyziolStanisława KluskaWitold JastrzębskiAnna AdamczykZbigniew GrzesikSławomir ZimowskiMarek PotoczekTomasz BrylewskiPublished in: Materials (Basel, Switzerland) (2022)
The results of plasmochemical modification on Crofer 22APU ferritic stainless steel with a SiC x N y :H layer, as well as the impact of these processes on the increase in usability of the steel as intermediate-temperature solid oxide fuel cell (IT-SOFC), interconnects, are presented in this work. The layer was obtained using Radio-Frequency Plasma-Activated Chemical Vapor Deposition (RF PA CVD, 13.56 MHz) with or without the N + ion modification process of the steel surface. To determine the impact of the surface modification on the steel's resistance to high-temperature corrosion and on its mechanical properties, the chemical composition, atomic structure, and microstructure were investigated by means of IR spectroscopy, X-ray diffraction (XRD), scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS). Microhardness, Young's modulus, wear rate, as well as electrical resistance, were also determined. Micromechanical experiments showed that the plasmochemical modification has a positive influence on the surface hardness and Young's modulus of the investigated samples. High-temperature oxidation studies performed for the samples indicate that N + ion modification prior to the deposition of the SiC x N y :H layer improves the corrosion resistance of Crofer 22APU steel modified via CVD. The area-specific resistance of the studied samples was 0.01 Ω·cm 2 , which is lower than that of bare steel after 500 h of oxidation at 1073 K. It was demonstrated that the deposition of the SiC x N y :H layer preceded by N + ion modification yields the best properties.