In Vitro Resistance of Natural Molars vs. Additive-Manufactured Simulators Treated with Pulpotomy and Endocrown.

Endocrowns are designed to restore endodontically treated teeth with root canal treatment (Rct). Recently, endocrowns were proposed for teeth treated with full pulpotomy (FP). No data exist on in vitro evaluations for this combination. This study aimed to evaluate the mechanical behavior of pulpotomy-treated teeth with endocrowns according to different protocols for preparation design and materials and to assess whether 3D-printed resin simulators could be a reliable alternative for human teeth during in vitro strength tests. One hundred and ten extracted natural molars were randomized into 11 groups according to the type of endodontic treatment, the material used, and the design of peripheric preparation. One hundred and ten resin simulators were separated similarly. The samples were embedded in epoxy resin blocks before being subjected to oblique compressive load until failure. For natural teeth, the variance analysis separated two homogeneous groups, one regrouping the endodontically treated or pulpotomy-treated teeth without coronal restoration and the other one regrouping all the other samples, i.e., the untreated teeth (positive controls) and the treated and restored teeth. The strength resistance was lower for the resin simulators than for natural teeth in all groups. Within the limit of this study, strength resistance is not the most important criterion for choosing the type of material, preparation, or endodontic treatment for endocrowns. Resin simulators are not efficient for in vitro strength studies.