One-Step Construction of the Positively/Negatively Charged Ultrathin Janus Nanofiltration Membrane for the Separation of Li + and Mg 2 .

To coordinate the trade-off between the separation and permeation of the nanofiltration membrane for the separation of Mg 2+ /Li + , we regulated poly(ethyleneimine)/piperazine interface polymerization parameters to construct a positively/negatively charged ultrathin Janus nanofiltration membrane at a free aqueous-organic interface. At the optimized interfacial polymerization parameters, 0.03 wt % of piperazine reacted with trimethylbenzene chloride prior to poly(ethyleneimine), forming a primary polyamide layer with fewer defects or limiting large-scale defects of the polyamide layer. The controlled subsequent reaction of poly(ethyleneimine) and trimethylbenzene chloride results in a Janus nanofiltration membrane, with one side enriched with the carboxyl groups, the other side enriched with the amine groups, and a dense polyamide structure in the middle. Under the optimum conditions, the positive potential of the rear surface of the prepared membrane was 14.57 mV, and the water contact angle reached 71.31°, while the negative potential of the front surface was -25.48 mV, and the water contact angle was 12.93°, confirming a Janus membrane with opposite charges and large hydrophilicity differences in the front and rear surfaces. With a high cross-linking degree, a 40 nm thick polyamide layer is 29.09% more thinner than the traditional polyamide membrane. The ultrathin Janus nanofiltration membrane showed an excellent separation factor ( S Li,Mg of 18.26), stability, and water permeability flux (10.6 L·m -2 ·h -1 ·bar -1 ). The rejections to MgCl 2 , CaCl 2 , MgSO 4 , and Na 2 SO 4 are measured above 90% at a nearly constant permeability of 10.6 L·m -2 ·h -1 ·bar -1 , particularly stable rejections to MgCl 2 and Na 2 SO 4 .