Experimental Analysis for the Performance Assessment and Characteristics of Enhanced Magnesium Composites Reinforced with Nano-Sized Silicon Carbide Developed Using Powder Metallurgy.

Magnesium, which is lightweight and abundant by nature, was widely used in the 19th century to make parts for automobiles and airplanes. Due to their superior strength-to-weight ratios, magnesium alloys were favored for engineering applications over unadulterated magnesium. These alloys result from the combination of magnesium with various metals, including aluminum (Al), titanium (Ti), zinc (Zn), manganese (Mn), calcium (Ca), lithium (Li), and zirconium (Zr). In this study, an alloy of magnesium was created using the powder metallurgy (PM) technique, and its optimal performance was determined through the Taguchi-Gray (TG) analysis method. To enhance the alloy's mechanical properties, diverse weight fractions of silicon carbide (SiC) were introduced. The study primarily focused on the Mg-Zn-Cu-Mn alloy, achieving the optimal composition of Mg-3Zn-1Cu-0.7Mn (ZC-31). Subsequently, composites of ZC-31/SiC were produced via PM and the hot extrusion (HE) process, followed by the assessment of the mechanical properties under various strain rates. The use of silicon carbide (SiC) resulted in enhanced composite densities as a consequence of the increased density exhibited by SiC particles. In addition, the high-energy postsintering approach resulted in a decrease in porosity levels. By integrating silicon carbide (SiC) to boost the microhardness, as well as the ultimate compressive and tensile strength of the composite material, we can observe significant improvements in these mechanical properties. The experimental findings also demonstrated that an augmentation in the weight fraction of SiC and the strain rate led to enhanced ductility and a shift toward a more transcrystalline fracture behavior inside the composite material.