Effects of H 2 O on Improving the Performance of a Solid Composite Electrolyte Fabricated via an Air-Processable Technique.

Inert atmosphere is normally necessary for fabrication of solid composite electrolytes (SCEs) as a crucial part of solid-state Li-metal batteries in order to avoid undesirable reactions induced by ambient moisture. Herein, we developed an air-processable technique to fabricate SCEs by employing LiCF 3 SO 3 (LiOTf) as the Li salt, which was combined with Li 6.4 La 3 Zr 1.4 Ta 0.6 O 12 (LLZTO) as the fast Li-conductor and polyvinylidene difluoroethylene/polyvinyl acetate (PVDF/PVAC) as the polymer matrix. With the assistance of trace H 2 O dissolved in electrolyte solution, the room-temperature Li + conductivity of the obtained aSCE reached as high as 5.09 × 10 -4 S cm -1 , which was over 3 orders of magnitude higher than that of the one (iSCE, 1.93 × 10 -7 S cm -1 ) cast by the electrolyte solution prepared in an inert atmosphere. The theoretical calculation results reveal that the oxygen atom of H 2 O exhibits a high propensity to interact with the Li atom in LiOTf (Li···O), thereby establishing a hydrogen bond with the oxygen atom (H···O) in N , N -dimethylformamide (solvent). Such interactions promoted the dissociation of LiOTf and led to the formation of uniform Li + transportation channels. Simultaneously, the composition distribution was also altered, resulting in a smoother surface of aSCE and lowered crystallinity of PVDF. On this basis, the LiOTf/LLZTO/PVDF/PVAC solution at 60 °C was directly coated onto the surface of the LiFePO 4 (LFP) cathode to fabricate the LFP-aSCE film after drying in an oven. The assembled LFP-aSCE/Li battery wetted by trace sulfolane exhibited an initial Coulombic efficiency of 94.7% and a capacity retention rate of up to 96% at 0.2 C (137 mAh g -1 ) after 180 cycles and a high capacity of 143.7 mAh g -1 at 0.5 C (150 cycles). Overall, this work could pave the way for the facile fabrication of solid electrolytes.