Additional in-series compliance does not affect the length dependence of activation in rat medial gastrocnemius.

The force-length relationship dictates the amount of force a muscle can produce as a function of its length, during maximal isometric contractions. When activation is submaximal, it has been shown that the length at which force production is highest (the optimal length) is longer. This is typically explained by a length-dependent increase in Ca2+ sensitivity, known as the 'length dependence of activation'. Recent reports have implicated shortening against in-series compliance to be a potential factor in the observed optimal length (L0 ) of muscle, via the phenomenon of shortening-induced force depression (a phenomenon which describes the relative reduction in muscle force when a muscle is actively shortening to a given length compared to contracting isometrically at that same length). In the current study, rat medial gastrocnemius was stimulated with single and triple pulses (200 Hz) over a range of lengths, both with and without additional in-series compliance provided by a small piece of silicon tubing in series with the muscle, which allowed greater fascicle shortening upon activation. Fascicle length was measured using sonomicrometry crystals, and peak force (Fpeak ) and L0 were estimated by curve-fitting of the force-length data. The additional in-series compliance significantly reduced Fpeak by approximately 14% and 25% for the single and triple pulses, respectively (P = 0.003, P < 0.001), yet L0 remained unchanged (P = 0.405), suggesting that in our model, shortening against in-series compliance does not affect L0 . We offer potential explanations for the discrepancies seen and discuss whether the velocity of shortening may have a role in the length dependence of force.