Login / Signup

Energetics of Nonradiative Surface Trap States in Nanoparticles Monitored by Time-of-Flight Photoconduction Measurements on Nanoparticle-Polymer Blends.

Xiaoqing GuoQianxun GongJoanna BorowiecSijie ZhangShuo HanMeng ZhangMaureen WillisTheo KreouzisKui Yu
Published in: ACS applied materials & interfaces (2019)
Nanoparticles (NPs) have had increasingly successful applications including in emissive or photovoltaic devices; however, trap states associated with the surface of NPs often drastically reduce the efficiency of devices and are difficult to detect spectroscopically. We show the applicability of photoconduction as the means of detecting and quantifying trap states in NPs. We performed time-of-flight (ToF) photoconduction measurements, using semiconducting poly[bis(4-phenyl)(4-butyphenyl)amine] (P-TPD) doped with either core/shell CdSeS/CdS quantum dots (QDs) or perovskite CsPbBr3 NPs, both of which are carefully designed to be energetically matched. In the case of the QDs, a drop in the hole mobility from ∼10-3 to ∼10-4 cm2 V-1 s-1 was observed when compared to a control sample, suggesting the presence of a hole trapping. These trap states were found to be around -5.0 to -4.9 eV from the vacuum level. The presence of the trap states was further supported by a coincident reduction in the photoluminescence (PL), quantum yield (QY), and lifetime of the core/shell QDs after purification. Using the measured reductions in the PL, QY, and lifetime, the surface trap state density was estimated to increase by between 20 and 40%, most likely due to a ligand detachment. In the case of the perovskite NP-doped samples, a mobility of ∼10-3 cm2 V-1 s-1 was measured. Thus, doping with perovskite NPs did not generate any obvious hole trapping from the P-TPD matrix. The absence of a trapping may be related to the reduced surface-to-volume ratio and NP number density of the perovskite NPs compared to the core/shell QDs, since the perovskite NPs are approximately 10 times larger in radius than that of the core/shell QDs. Our results suggest that to minimize the presence of trap states with a view to improving device performance, large-size perovskite NPs appear to be better than small-size QDs.
Keyphrases
  • solar cells
  • quantum dots
  • room temperature
  • high efficiency
  • oxide nanoparticles
  • sensitive detection
  • mass spectrometry
  • perovskite solar cells