Designing Superlubricious Hydrogels from Spontaneous Peroxidation Gradients.
Allison L ChauChelsea E R EdwardsMatthew E HelgesonAngela A PitenisPublished in: ACS applied materials & interfaces (2023)
Hydrogels are hydrated three-dimensional networks of hydrophilic polymers that are commonly used in the biomedical industry due to their mechanical and structural tunability, biocompatibility, and similar water content to biological tissues. The surface structure of hydrogels polymerized through free-radical polymerization can be modified by controlling environmental oxygen concentrations, leading to the formation of a polymer concentration gradient. In this work, 17.5 wt % polyacrylamide hydrogels are polymerized in low (0.01 mol % O 2 ) and high (20 mol % O 2 ) oxygen environments, and their mechanical and tribological properties are characterized through microindentation, nanoindentation, and tribological sliding experiments. Without significantly reducing the elastic modulus of the hydrogel ( E* ≈ 200 kPa), we demonstrate an order of magnitude reduction in friction coefficient (from μ = 0.021 ± 0.006 to μ = 0.002 ± 0.001) by adjusting polymerization conditions (e.g., oxygen concentration). A quantitative analytical model based on polyacrylamide chemistry and kinetics was developed to estimate the thickness and structure of the monomer conversion gradient, termed the "surface gel layer". We find that polymerizing hydrogels at high oxygen concentrations leads to the formation of a preswollen surface gel layer that is approximately five times thicker ( t ≈ 50 μm) and four times less concentrated (≈ 6% monomer conversion) at the surface prior to swelling compared to low oxygen environments ( t ≈ 10 μm, ≈ 20% monomer conversion). Our model could be readily modified to predict the preswollen concentration profile of the polyacrylamide gel surface layer for any reaction conditions─monomer and initiator concentration, oxygen concentration, reaction time, and reaction media depth─or used to select conditions that correspond to a certain desired surface gel layer profile.