Fluid drag reduction by penguin-mimetic laser-ablated riblets with yaw angles.

The bodies of penguins, which swim underwater to forage, are densely covered with feathers, in which the barbs are oriented in the longitudinal direction. We hypothesize that these barbs act as riblets and reduce friction drag during swimming. Considering various real-world swim conditions, the drag reduction effect is expected to be robust against changes in the flow speed and yaw angle relative to the flow. To test this hypothesis, we created trapezoidal riblets based on the morphology of these barbs and measured the drag of flat plates with these fabricated riblets in a water tunnel. The spacing, width, and height of the barbs were found to be approximately 100, 60, and 30  μ m, respectively. This spacing resulted in a nondimensional spacing s + of 5.5 for a typical penguin swimming speed of 1.4 m s -1 . We fabricated four types of riblets on polyimide films by ultraviolet laser ablation. The first was a small-scale riblet for which the spacing was decreased to 41  μ m to simulate the surface flow condition of the usual and slower swim behaviors in our water tunnel. The other three were manufactured to the actual scale of real barbs (spacing of 100  μ m) with three different rib ridge widths: 10, 25, and 50  μ m. Yaw angles of 0°, 15°, 30°, and 45° were also tested with the actual-scale riblets. The drag reduction rate of the small-scale riblet was maximized to 1.97% by the smallest s + of 1.59. For all three actual-scale riblets, increasing the yaw angle from zero to 15° enhanced the drag reduction rate for the full range of s + up to 13.5. The narrow-ridge riblet reduced drag at an even higher yaw angle of 45°, but the drag increased with zero yaw angle. Overall, the medium-ridge riblet, which was representative of the barbs, was well-balanced.