Use of Limestone Sludge in the Preparation of ɩ-Carrageenan/Alginate-Based Films.
Pedro AdãoMaria da Luz CaladoWilson FernandesLuis G AlvesLeonor Côrte-RealMafalda GuedesRicardo BaptistaRaul BernardinoMaria Manuel GilMaria Jorge CamposSusana BernardinoPublished in: Materials (Basel, Switzerland) (2024)
The use of processed limestone sludge as a crosslinking agent for films based on Na-alginate and ɩ-carrageenan/Na-alginate blends was studied. Sorbitol was tested as a plasticizer. The produced gel formulations included alginate/sorbitol and carrageenan/alginate/sorbitol mixtures, with tested sorbitol concentrations of 0.0, 0.5 and 1.0 wt%. The limestone sludge waste obtained from the processing of quarried limestone was converted into an aqueous solution of Ca 2+ by dissolution with mineral acid. This solution was then diluted in water and used to induce gel crosslinking. The necessity of using sorbitol as a component of the crosslinking solution was also assessed. The resulting films were characterized regarding their dimensional stability, microstructure, chemical structure, mechanical performance and antifungal properties. Alginate/sorbitol films displayed poor dimensional stability and were deemed not viable. Carrageenan/alginate/sorbitol films exhibited higher dimensional stability and smooth and flat surfaces, especially in compositions with 0.5 wt% sorbitol. However, an increasing amount of plasticizer appears to result in severe surface cracking, the development of a segregation phenomenon affecting carrageenan and an overall decrease in films' mechanical resistance. Although further studies regarding film composition-including plasticizer fraction, film optimal thickness and film/mold material interaction-are mandatory, the attained results show the potential of the reported ɩ-carrageenan/alginate/sorbitol films to be used towards the development of viable films derived from algal polysaccharides.