Evaluation of Preferred Binding Regions on Ubiquitin and IgG1-F C for Interacting with Multimodal Cation Exchange Resins using DEPC Labeling/Mass Spectrometry.

There is significant interest in identifying the preferred binding domains of biological products to various chromatographic materials. In this work, we develop a biophysical technique that uses diethyl pyrocarbonate (DEPC) based covalent labeling in concert with enzymatic digestion and mass spectrometry to identify the binding patches for proteins bound to commercially available multimodal (MM) cation exchange chromatography resins. The technique compares the changes in covalent labeling of the protein in solution and in the bound state and uses the differences in this labeling to identify residues that are sterically shielded upon resin binding and therefore potentially involved in the resin binding process. Importantly, this approach enables the labeling of many amino acids and can be carried out over a pH range of 5.5 to 7.5, thus enabling the protein surface mapping at conditions of interest in MMCEX systems. The protocol is first developed using the model protein ubiquitin and the results indicate that lysine residues located on the front face of the protein show dramatic changes in DEPC labeling while residues present on other regions have minimal or no reductions. This indicates that the front face of ubiquitin is likely involved in resin binding. In addition, surface property maps indicate that the hypothesized front face binding region consists of overlapping positively charged and hydrophobic patches. The technique is then employed with an IgG1 F C and the results indicate that residues on the C H 2-C H 3 interface and the hinge are significantly sterically shielded upon binding to the resin. Further, these regions are again associated with significant overlap of positively charged and hydrophobic patches. On the other hand, while, residues on the C H 2 and the front face of the IgG1 F C also exhibited some changes in DEPC labeling upon binding, these regions have less distinct charged and hydrophobic patches. Importantly, the hypothesized binding patches identified for both ubiquitin and F C using this approach are shown to be consistent with previously reported NMR studies. In contrast to NMR, this new approach enables the identification of preferred binding regions without the need for isotopically labeled proteins or chemical shift assignments. The technique developed in this work sets the stage for the evaluation of the binding domains of a wide range of biological products to chromatographic surfaces, with important implications for designing biomolecules with improved bio-manufacturability properties. This article is protected by copyright. All rights reserved.